Instructions

Video Instructions

 

Written Instructions

InstructionsYour Vinyl arrives as a pre-spaced sheet of letters made up of three layers.
A – the top layer – or the transfer tape (through which you can see the letters)
B – the middle layer – which are the letters and
C – the bottom layer – or the white/blue shiny backing paper.

If your order has been shipped, gently press the vinyl sheet flat before proceeding with instructions

    Instructions 2
  1. Position Your Letters
    1. Position your vinyl sheet on the wall, centering the letters, and securing it with masking or painting tape. (The tape acts as a hinge for the project.) You can see the lettering through its semi-transparent top layer.

  2. Instructions 3
  3. Remove the Backing
    1. Flip the lettering sheet upward and slowly peel off the bottom layer. Let the lettering rest on the semi-transparent top layer. (If the lettering wants to stick to the backing, slowly manipulate the backing to help the letters stick to the top layer.)

  4. Instructions 4
  5. Rub the Letters Onto the Wall
    1. Use some kind of hard but gentle edge like a large tongue depressor, wide popsicle stick, or plastic scraper, and firmly rub over the semi-transparent top layer to secure the lettering to your wall. Work from the center out on both sides letting the edger act as a squeegee over the lettering.

  6. Instructions 5
  7. Peel Off the Transfer Tape
    1. Then, carefully peel off the sticky top layer to reveal your letters.


  8. You’re Done!
      Instructions 6
    1. Removal: When it comes time to remove your vinyl letters, remember that the heat of a blow dryer will soften the vinyl and make it easier to peel off.
satisfaction guarenteed
check out all of our colors
5 dollar shipping